The Gate Arch is of a different geometry than our other arches, in that the arch is shorter than the wheels are tall.  These are some tall tires, but then again the arch isn’t that big; with the outside of the wheels at 35inches in width.  When the arch is inverted it becomes a tremendous hauler of brush and branches, with the addition of our brush package that adds another set of Bunks, two sets of Stakes and an extension handle we call the Gooseneck.  The Gooseneck changes the handle height for ergonomic handling of logs in arch mode and again a great handle height for hauling brush.

The Gate Arch is very specifically made to fit through 36” gates with room to spare.  It will pick up logs very easily up to 20” in diameter and carry them just a couple inches off the ground for lawn applications.  The effort to lift the logs is minimal and the tall tires roll very easily.  The lifting is accomplished with a choker chain and is pulled up tight into the arch with an over-centering action.  The load capacity is 1 ton of weight, though it is unlikely that a log of that weight would be 20”dia.  The Arch is engineered to stand up to anything and we stand behind it for a lifetime of use.

The Gate Arch is the only device of it’s kind, and it can be used for both logs and brush.  When the arch is flipped over inside it’s tall tires, it becomes a cradle and, with the addition of our brush package, can haul a tremendous amount of brush in one load – through the same gate.  The Brush package includes another set of “Bunks” like the arch becomes when inverted, as well as Stakes that extend the cradle to nearly 6feet in height.  This is as much brush as you can pile into a pickup truck and all of it can travel through the gate and out to the chipper.